Low

DM330023-2 - 

Development Board, Motor Control, dsPICDEM™ MCHV-2

Kuva on vain kuvaavaa tarkoitusta varten. Lue tuotekuvaus tarkempia tietoja varten.

Valmistajan osanumero:
DM330023-2
Tilauskoodi:
2251940
Tekninen tuotetietolomake:
(EN)
Näytä kaikki tekniset asiakirjat

Tuotetiedot

:
dsPIC33EP256MC506
:
dsPIC33EPxxxMCxxx, PIC24FJxxGBxxx
:
AC Induction or Brushless Motor
:
Power Management - Motor Control
:
PIC24, dsPIC33
:
-
:
Development Board dsPICDEM MCHV-2, Matrix Board, USB Cable, Screw Driver
:
PIC, dsPIC
:
Microchip
Löydä vastaavia tuotteita Voit etsiä vastaavia tuotteita valitsemalla ja muokkaamalla yllä olevia valintoja.

Tuotteen yleiskatsaus

DM330023-2 is a dsPICDEM MCHV-2 development system intended to aid the user in rapid evaluation and development of a wide variety of applications using a dsPIC digital signal controller. This system is targeted to BLDC motors, PMSM and ACIM in sensor or sensorless operation. This flexible and cost effective tool can be configured in different ways for use with specialized motor control DSCs. It supports the dsPIC33F and dsPIC33E motor control device family and offers a mounting option to connect either a 28 pin SOIC device or a generic 100 pin PIM. The system has a three phase power module device that contains motor inverter and gate driver's circuitry. The circuit drives a BLDC, PMSM or ACIM motor using different control techniques without requiring any additional hardware. The MCHV-2 supports using either the internal opamps found on certain dsPIC33E products or external opamps found on MCHV-2 board for current sensing. It also has PFC circuitry to meet power regulatory requirements.
  • Maximum output 1000W at 400V
  • Current feedback circuitry and zero crossing detection
  • DC bus sensing and over current protection
  • Three phase inverter (IPM) 400V/6.5A
  • Hall sensors and quadrature encoder interface (QEI)
  • Phase voltage feedback for sensorless BEMF operation
  • DC bus current sense resistor for single shunt resistor vector control
  • Phase current sense resistors for dual shunt resistor vector control
  • Input voltage range 85VAC to 265VAC
  • In rush current limiter, EMI filter, 250 VAC/15A fuse

Sovellukset

Motor Drive & Control

Sisältö

DsPICDEM MCHV-2 development board, dsPIC33EP256MC506 internal op amp PIM (MA330031), Matrix board to configure the MCHV-2 for internal on chip opamp use, Matrix board to configure the MCHV-2 for external on board opamp use, USB cable assembly, Screw driver.

Lisähuomautukset

90 Day Warranty only. After Expiration of Warranty returns must be processed via Microchip.

Varoitukset

This system must be earthed (grounded) at all times.